Pages

Sunday, September 1, 2013

Sandals for Tiny Kitty

Going through the resin soles I made on my first attempt at casting resin, I noticed some for Tiny Kitty and decided to make shoes using them. I started by making the insoles using card stock and leather. That way, I could continue with the uppers while waiting for the paint to dry.


I attached the resin soles to a support using double-sided mounting tape, so I could paint all sides except the top at once. I was using enamel paints and with them, the result is better, if you can paint all at once. I use mounting tape, because it is so thick that the sole does not touch the support.


Here are the soles after first coat of paint.


I wanted to use leather for the straps, but it is too thick to turn under the insoles when making shoes as small as these. So I cut the straps without any extra and made notches on the sides of the insoles for the ends of the straps.


Then I glued small strips of fabric at the ends of the straps.


And glued the straps into the notches, turning the fabric strips under the insoles. You could do this without the fabric, but the glued surface would be very small and I wouldn't trust it to hold. So the fabric is just for extra security.


I don't have pictures of the rest of the steps, but they are very simple. Just attach the straps for the toe parts the same way, glue the insoles in place and close the straps by attaching a bead to one side and making a hole to the other. You can see it below in the photos of the finished shoes.



I was planning to use some decorations on the straps, but I thought these looked so good like this that I discarded that plan. I can make another pair for that experiment.

No comments:

Post a Comment